DIY Hydro Dipping

Seriously considered but looked like more trouble than it was worth especially when you compare the cost to what you could cerakote the gun for and get a far more durable finish so that's the route I went. I've also had great results twice using a mossy oak vinyl kit. They look good if you take your time installing and use a heat gun. Best of all, when you scratch it, pull it off and replace it for +\-$30 whereas with dipping it would be a costly repair.
 
I have considered it several times but figured my OCD would kick in if I didn't get it right and I wouldn't like it and it just be a waste.


Sent from my iPhone using Tapatalk
 
I've looked into it some on YouTube but if I do anything will probably be to paint it. But if you do it be sure to post it might change my mind for me lol
 


Write your reply...

Latest posts

Back
Top