TheAirMan
Well-Known Member
maybe. Watch after I post this something else will go wrong. I been on this build a long time. Partly because I had to learn what all I had to do and partly because I wasn't in a hurry. Also, sometimes I just wasn't in the mood to mess with it. I actually finished it up last weekend. However, the camera wouldn't record when the board brought the camera on. After checking and trying this and that Chris sent me a new board and relay. I got everything hooked up yesterday and it's recording now. I wasn't happy with the wiring last weekend. Since I knew I was going to have to unhook some of the wiring anyway, I bought me a little project box to put the sister boards, drivers, and relay in. I also decided to ditch the 9 volt and get a resister so the 12v sla would run the exchanger too. Why I didn't do that to start with is beyond me. Anyway I am not completely done yet. Last weekend when I was messing with the camera and board, one of the factory mic wires inside the camera came loose. I got to take the camera back apart and hook a wire back up. Since I have to be in there anyway, I am going to make the wires long enough to come down and be put in a servo connector. That way I can just unplug the camera to take it out. That is another thing I should have done to start with. That and the resistor and I may be done. Just imagine the wires coming out of the camera and the bottom of the project box cut to the same lengths and put in a servo connector. That will pretty much be how it will look on the inside. I will probably do the 3D camo on the outside after I know everything is working right.
