I purchased a new 20 gauge and it hits high and to the left with every choke tube I have. Throws a great pattern but just 8 inches high and left. Any suggestions?The gun is not drilled or tapped. I was shooting off a rest and very still. Thank You!
-
Help Support TNDeer:
POI
- Thread starter deerfever
- Start date
What gun is it?
Its a Tri star raptor youth. Gun has cycled every shell I have shot through it low brass, high whatever. It just shoots high and left. I hate that as again I was very pleased with performance just need to figure this out. If it was just high I could simply aim a little lower but shooting to the left also puts a man in a bind when a big Tom walks up! I have the beard buster sights on my two other 20 gauge set ups, I think they allow for some adjustment, I just wanted to see if you guys had any other thoughts. I appreciate your help! I have already called Tri star and they said I could send it back and they would take a look but did not know if it was necessary or would help.
Call tri Star
fairchaser
Well-Known Member
You might be able to use some padding or a buttplate adjustment so that you mount the gun with the best sight orientation. My Mossberg shot off and high too and after I added a red dot it's perfect. The issue is that not everyone has the same face or distance from their face to their eye. It's likely not the gun but the fit.
prstide
Well-Known Member
If it's consistently throwing the pattern to the same spot put some adjustable sights on it.
Williams fire sights, by once and be donedeerfever":1ewbqazn said:
prstide
Well-Known Member
Williams fire sights are well made(in the USA). Tru Glo has some all metal sights that are similar also.
http://www.truglo.com/firearms-turkey/p ... le-dot.asp
http://www.truglo.com/firearms-turkey/p ... le-dot.asp
PickettSFHunter
Well-Known Member
You can adjust the beardbuster sights, not as much as others but they can be adjusted by moving the rear sight left and right and moving it up and down the rib.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
turkeyhunter
Well-Known Member
have it drilled and tap. Add a red dot scope.
Thanks for all the advice! I am going to try adjustable sights first and if that does not satisfy,sun optics makes a rail part # sm 7015 that they say will fit and no need to drill and tap. The gun has grooves on the top of the receiver and the part should work great to mount a scope!
^^^^Great news, which sights did you go with?
