PSE Shooters..

[TheAirMan]

anybody have trouble with their factory string stop causing noise or vibration. My Bow Madness XS has developed a twang and a little vibration that it didn't used to have. I have tightened and checked accessory screws, draw mod screws, draw stop, cable rod, and about everything else. I don't really see the string stop doing this but I guess it could. The reason I think it might is the rubber stopper can move on the rod. I assume it should be able to though, with a certain amount of force, since they sell replacement stoppers. I found the stop to work the best with just a little gap of light between it and the string. After setting it, which is easier said than done with the way you adjust the thing, I noticed after a few shots it has worked its way back to touching the string.

 

[TheAirMan]

Never mind. Not the string stop or at least it still did it with it off. Along with the quiver mount and the stabilizer. I guess I'll have to do a little more searching.

 

[Radar]

Check to make sure the cam is rolling over properly and the string hasn't developed some creep . Those lower end PSE strings are junk ! I have one on my Mach X .

 

[TheAirMan]

I am not sure how I can see if it's rolling over properly. I do know that going by the marks on the cam the cam is rotated pretty much where it always has been. Although it still may have some creep it's a Bucknasty string instead of the factory one. I tried this a minute ago. I just plucked the string on my DXT, and it makes a little thump. I did it on my XS and I get a buzz and can actually feel the bow vibrating in my hand just by doing that. I might have always could I'm not sure. I just found that odd.