Livescope question

[TRIGGER]

I am running 2 transducers on my 8612. I was running 2 LVS 34's but just switched one of the 34's out for an XR 62. New transducer and new GLX 10 box. I'm getting a "source not found" message for the new 62. I have plenty of voltage to the box and the unit. Any ideas?

 

[Spurhunter]

The only time I've seen "source not found" it was either:
A bad connection (I guess). I unplugged the cables and reconnected.
Or:
My unit changed to another transducer that didn't exist. I had to go into the menu and select the correct one.
I'm sure you've already checked those two things so I will defer to @bluball

 

[TRIGGER]

The only time I've seen "source not found" it was either:
A bad connection (I guess). I unplugged the cables and reconnected.
Or:
My unit changed to another transducer that didn't exist. I had to go into the menu and select the correct one.
I'm sure you've already checked those two things so I will defer to @bluball

Did some reading and believe I have to reset the unit. What I found said the unit is looking for the old box and not recognizing the new. I'll try it later