New Fleshing Beam - Need Advice

[BigRed1080]

Hello All!

I just got a new fleshing beam and want to try a new setup. I had it previously fixed to the base of a wall at 45ish degrees and it never moved. I would like to have a setup I could pull out and clean behind and put away after all the fur is put away. Any suggestions? Or anyone want to show off they set up? Thanks

PS: The new beam I got is the Minnesota Trapline Fleshing Beam 7x48 so its not a small one or table top version.

 

[Trapper]

I have mine on a hinge on the wall , take the strap off that's holding it up then it folds down with the stand. When I'm done I wipe it off then fold it back up then clean the floor up . I will take a picture tomorrow if you want to see it .

 

[Shanman]

Just a side note for keeping the floor clean.
I use a large piece of cardboard and sprinkle a heavy dose of Borax on it, really helps the fat and grease from smearing everywhere, also makes for easy cleanup.