Savage model 10 ML -II

[Tru2Life]

Bulged barrel at the end about 1 1/4"

Anyone know if anything could be done or is this ruined?

50 cal savage model 10 ML-II

 

[swampbadger]

whoa, I'd get another ML.

I'd just throw it in the shed till you hear about a gun buy back or something.

 

[Remi]

Cut 2" off of it and recrown it

 

[jlanecr500]

You can take the barrel off and have it cut shorter and re- crowned. Before getting that done, you need to check the rest of the barrel for bulges. Remove the plug and push a bullet thru. If the bullet gets excessively loose at any point below the bulge, there is another bulge

 

[Jcalder]

Cut 2" off of it and recrown it

Easiest fix there is

 

[Tru2Life]

Yall know anyone that cut and recrown before Dec 20th Iowa muzzleloader hunt

 

[Tru2Life]

Desperate here

 

[Remi]

I did my encore with a Sawzall and crowned it with an inside the case mouth chamfer tool


Mine had a QLA on the end that was off center and it didn't shoot good

Taped it off, measured, Sawzall, "crown", done


It shoots much better now


I shoot a fixed 4x leupold


3 at 125yds before I cut it


4 at 125yds after I cut it

 

[Jcalder]

Desperate here

Bugholes could probably get it done by then. They're in cookeville

 

[ImThere]

Junk. I'll pm you my address so I can throw it out for you! your lucky (unfortunately) they told you the fix above. What caused it? I have no idea about the timeline. Good luck maybe someone can help you out

 

[Turkeychaser]

What caused it?

 

[knightrider]

I have an accura you can take if you cant get it fixed

 

[Tru2Life]

I have an accura you can take if you cant get it fixed

Thanks!!!!

 

[knightrider]

Thanks!!!!

I have three you can pick from, and your more than welcome