I have a 20ga m2 Benelli that jams with regular field loads but want with hi brass field loads. It's clean and had maybe a case shot through it. Any ideas ? I'm thinking Maybe recoil spring.
-
Help Support TNDeer:
Benelli m2?
- Thread starter THE DUKE
- Start date
My Cordoba 20 wouldn't cycle Rio field loads. I called Benelli and the guy said Rio shells were the problem. Seriously? That's a high dollar shotgun that should feed anything run through it.
Bambi Buster
Well-Known Member
FWIW, 50 years ago Browning made a similar argument about Federal shotgun shells in their A5 shotguns.
deerfanatic
Well-Known Member
What powder charge? My black eagle doesn't like those super cheap light load ones from wm. I try and shoot 1 1/8 oz
Usually 7/8 if I find 1oz I get those. Winchester or federal brand.
deerhunter10
Well-Known Member
I've had zero trouble with my m2 with cheap light loads. Sounds crazy but are you shouldering it tight that can by an issue with with inertia guns.
Could be spring weirdly as well. Send it back to benelli.
Could be spring weirdly as well. Send it back to benelli.
I had a similar issue with a Franchi Affinity 3. Sent it back for warranty work. They sent it back and said all was well. I recorded it and sent an email of the recording. They took it back under warranty a second time and determined it was a broke/weak spring. They replaced it and it has run flawlessly ever since.
I'm not the original owner, I bought it from someone here not sure if it would be covered. I also have a m2 in 12 ga and a stoeger 3020 in a 20ga that will shoot any shell you put in it. This one seems like it dragging when you pull the bolt back and release it. Sometimes it doesn't have enough force to twist the bolt head where it will fire.
- Joined
- Feb 25, 2015
- Messages
- 253
- Reaction score
- 204
Sure Cycle? Details on that?
Im fixing to get a 3020 and it'll need to eat the spectrum from light loads to 3" steel and turkey stuff.
- Joined
- Feb 25, 2015
- Messages
- 253
- Reaction score
- 204
Sure Cycle is a aftermarket stainless steel spring and carrier tubing that replaces the assembly in the rear of many inertia operated shotguns. I am sure now there are other manufacturers. This is the weak link in this gun design as water, powder and dirt make it's way into the the assembly by the plunger opening at the rear of the receiver. This slows down the cycle and the problems begin.
- Joined
- Feb 25, 2015
- Messages
- 253
- Reaction score
- 204
Also, the reason it first shows up is that heavy loads slam the assembly back and the spring pushed into the end of its battery has enough energy to cycle the bolt. Weaker shells, low brass don't have this inertia to cycle correctly. The older the gun and the less maintenance it has seen the problem will start to arise sooner.
